Falcon Quad E3/DS3 TIM

E3/DS3 ATMÀ» 4°³ ÀÔ·Â¹Þ¾Æ Controller ¸ðµâ ¹× Network Interface ¸ðµâÀ» ¿¬°áÇÏ´Â Tributary Interface
ÇϳªÀÇ ATM ½ÅÈ£¿¡ ¹®Á¦ ¹ß»ý½Ã ÀÚµ¿À¸·Î ½ºÀ§Äª ÇØÁÖ´Â º¸Á¶ ATMÀԷ žÀç
RS-232 ÄÁÆ®·Ñ  
Features
• 4x E3/DS3 ATM tributary interfaces (software configurable)
• Redundant ATM input (Automatic Protection Switching)
• Full VPI/VCI range
• E3 (G.703) or DS3 (ANSI T1.107la)
• Line Coding E3: HDB3, DS3: B3ZS
• Modes E3: G.832 ADM, G.751 ADM, G.751 PLCP
• Modes DS3: CBIT ADM, CBIT PLCP, M23 ADM, M23 PCLP
• Local CPU
• Local storage of configuration parameters
• Hot-Swap and Hot-Plug
• SNMP support

Application
The Quad E3/DS3 service card (TIM) supports 4 ATM E3 or DS3 interfaces. The interfaces can
be configured as E3 or DS3 independently via software. Different modes and line coding can be
selected.
The module supports PLCP as well as ADM framing.
The Quad TIM card supports Automatic Protection Switching (APS) on every E3/DS3 link. A
redundant ATM input can feed the interface. In case one link fails the ATM cell stream is switched
automatically to the second link. The incoming E3/DS3 traffic can be sent via two links towards
two network interface cards if installed in a Falcon.
The card can be configured using the console port (RS232) or in combination with an installed
controller card via Ethernet networks. All configuration parameters are stored locally and nonvolatile.
The entire function of the module is controlled by the on-board CPU. The firmware is
stored in the on-board Flash memory.
The card supports hot-plug and hot-swap according to the Compact-PCI specification.
                   

 
¸ñ·Ï